WEISS TR0750A - Page 79

79 pages

To Previous Page

WEISS GmbH

Siemensstraße 17 74722 Buchen

Telefon 06281 5208-0 Telefax 06281 5208-99

info@weiss-international.com

www.weiss-international.com

Main Page

Default Chapter2
- Table of Contents2
1 Introduction5
- About These Mounting Instructions5
- Intended Use5
- Predictable Incorrect Application5
- Applicable Documents6
- Warranty7
2 Safety8
- Safety Messages and Hazard Categories8
- Hazard Symbols8
- Responsibilities of the System Integrator And/Or Operator9
- Qualification of Personnel9
3 Product Description10
- Overview10
- Function Description12
- Nameplate13
- Type Code13
- Mounting Positions14
- Drive Positions15
- Passage of Media16
4 Technical Data17
- General17
- Motor17
- Holding Brake20
- Inductive Sensor20
- DRIVE-Cliq Encoder (Optional)20
- Climatic Environmental Conditions "Operation21
- Climatic Environmental Conditions "Transportation and Storage21
- Dimensions22
- Load Data26
5 Packaging27
- Types of Packaging27
- Unpacking the Product27
- Verification of the Delivery27
6 Transportation28
- Transporting the Product28
- Load Lifting and Handling Equipment29
- Fastening the Load Lifting and Handling Equipment29
7 Storage31
- Storing the Product31
8 Mounting32
- Prerequisites for Mounting32
- Equipment and Tools32
- Tightening Torques and Property Classes33
- Bolting down the Product33
- Displacing the Drive Housing34
- Mounting Additional Components36
- Mounting Safety Equipment39
9 Electrical Connection40
- Connection Diagram Supply Voltage40
10 Controller42
- Basic Information on Control42
- External Controller (PLC)43
11 Commissioning45
- Prerequisites for Commissioning45
- Performing Commissioning45
12 Operation47
- Basic Information on Operation47
13 Troubleshooting48
- Issue, Cause and Remedy48
14 Cleaning50
- Performing Cleaning50
15 Maintenance52
- Maintenance Plan52
- Lubricant52
- Replacing the Motor52
- Inspecting the Toothed Belt57
- Replacing the Toothed Belt59
- Inspecting the Holding Brake62
- Readjusting the Air Gap of the Holding Brake64
- Replacing the Holding Brake67
- Replacing the Inductive Sensor72
16 Decommissioning76
- Decommissioning the Product76
17 Dismounting76
- Dismounting the Product76
18 Disposal76
- Disposing of the Product76
19 Service and Spare Parts77
- Worldwide Service77
- Ordering Spare Parts78

WEISS TR0750A - Page 79

Table of Contents

Related product manuals