Excessive microwave energy
WARNING
Risk of burns from excessive microwave energy
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
Do not attempt to operate this oven with the door open since open-door operation can result in harmful exposure to
microwave energy. It is important not to defeat or tamper with the safety interlocks.
Do not place any object between the oven front face and the appliance door or allow soil or cleaner residue to
accumulate on sealing surfaces.
Do not operate the oven if it is damaged. It is particularly important that the oven door closes properly and that there is
no damage to the (1) door (bent), (2) hinges, (3) door seals and sealing surfaces.
The oven should not be adjusted or repaired by anyone except properly qualified service personnel.
Radio interference
NOTICE
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
Reduce or eliminate interference to radio, television, or other electrical appliances by doing the following:
▪ Place electrical appliances as far away from the microwave combination oven as possible.
▪ Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.
Interférence radio
AVIS
Produit de classe A. Dans un environnement domestique, ce produit peut occasionner des interférences radio
imposant à
l’utilisateur de prendre des mesures adéquates.
Réduire ou éliminer les interférences vers la radio, la télévision ou tout autre appareil électrique
en effectuant ce qui suit :
▪ Placer les appareils électriques aussi loin que possible du four combiné à micro-ondes.
▪ Utiliser une antenne, correctement installée, sur la radio, la télévision, etc. pour obtenir une meilleure
réception du signal.
7.2 Procedure for preparing the appliance for use
Checks prior to preparing the appliance for use
Before preparing the microwave combination oven for use, use the checklists below to make sure that all important
requirements are met. The appliance must not be put into operation until all the specified requirements are met.
Checklist for moving, setting up and installing the appliance:
▪ Cardboard packaging and transport securing devices etc. have been removed completely from the appliance.
▪ The appliance has no signs of damage.
▪ The appliance has been set up so that it cannot slide about or tip over; the requirements for the installation position and
the area around the appliance have been met.
▪ The appliance is installed in accordance with the installation regulations.
Checklist for safety devices and warnings:
▪ All safety devices are in their designated position, are working correctly and are secured properly in place.
▪ All warning signs are in their designated position.
To Next Page
Loading...
Need help?
General
