8. To store data for later review or printing:
1.
Makesure
unit is ON.
2. Match pattern on button with observed ear.
3. Depress appropriate MEMORY
(t
3)
button.
4. To insure data entry into memory observe memory
symbol on screen.
CAUTION: Holding the MEMORY button down for more than
3 seconds will cause memory to be erased.
9.
To
start
new test, depress START/RUN
(6-D)
button.
10. Tips may be removed by hand or by sliding the
toward the tio.
white tip ejector
1
I.
To
print
results, use Printer/Charger
#71130
(pg. 16).
12. To display right
(
F
)
or left
(
3
)
memory contents, press
appropriate memory button.
13. To erase right
(
F
)
or left
(
3
)
memory contents, depress
appropriate memory button continuously for 3 seconds. BLANK
MEMORY (--
)
symbol will appear.
14. The
MicroTymp
will turn OFF automatically 40 seconds after the
last test or last actuation of any button. Contents of memory are
not lost when the unit turns OFF.
8
To Next Page
Loading...
Need help?
General
