Welch Allyn SureTemp Plus 690 Series User Manual

8 Welch Allyn SureTemp Plus
Button Functions
Set-Up
ASSEMBLING THE UNIT
Your SureTemp Plus thermometer is shipped to you with three 1.5V AA batteries installed.
1. Install the oral/axillary probe (blue ejection button) or optional rectal probe (red Ejec-
tion button) by inserting the latching probe connector on the end of the coiled cord
into the unit’s plug receptacle. Ensure that the connector snaps into place. The LCD
will illuminate for approximately 7 seconds and will then turn off.
2. Connect the appropriate removable probe well to the thermometer. Note that the cut-
out in the probe well fits over the probe cord strain relief. Ensure that the removable
probe well “snaps” into position and is completely seated to the thermometer. Place
the probe into the well.
3. Insert the box of Welch Allyn disposable probe covers into the probe cover storage
holder. To open the box of probe covers, remove and discard the tear-away corner. You
will see the ends of the probe covers in the box.
MOUNTING THE UNIT
Mount the wall-mount bracket in a location such as an interior wall or wall divider so that
the thermometer remains at ambient room temperature. Mounting the unit on an
Buttons Procedure
C/F Press and release the C/F (Celsius/Fahrenheit) button to toggle
between temperature scales any time a temperature is displayed
on the LCD.
Pulse Timer/Monitor
Mode (692 Only)
Press and release the Pulse Timer/Monitor Mode button to
activate the timer. Audible beeps sound at 0, 15, 30, 45, and 60
seconds. The timer turns off automatically after 60 seconds. You
can stop the timer at any time by pressing the Pulse Timer/
Monitor Mode button or by removing the probe from the probe
well.
For Monitor Mode, press and release the Pulse Timer button
after you have withdrawn the probe from the probe well to
switch the device into Monitor Mode.
Mode Selection Press and release the Mode Selection button after you have
withdrawn the blue probe from the probe well to change the
current measurement site to Oral, Adult Axillary, or Pediatric
Axillary. The selected measurement site is displayed by a
flashing body site icon. Note that no other measurement sites
are available when using the red probe in the Rectal Mode.
Recall Press and release the Recall button when the display is blank to
recall the last completed predicted temperature. The LCD will
display the recalled temperature for five seconds along with the
battery icon, temperature scale, mode selection, and probe-
position icon (if applicable).

Welch Allyn SureTemp Plus 690 Series Specifications

General

Brand	Welch Allyn
Model	SureTemp Plus 690 Series
Category	Thermometer
Language	English