Directions for use 19
solution as the active disinfection ingredient. Clean the probe well's outer surface by
swabbing or wiping the surface with one of the solutions mentioned above.
• Thoroughly dry all surfaces before re-assembling the instrument.
• Re-connect the latching probe connector to the thermometer. Ensure that the
connector snaps into place.
• Re-install the probe well in the thermometer and snap the probe well into place.
• Insert the probe into the probe well.
Disposal
DISPOSING OF EQUIPMENT
Do not dispose of this product as unsorted municipal waste. Prepare this product for
reuse or separate collection as specified by Directive 2002/96/EC of the European
Parliament and the Council of the European Union on Waste Electronic and Electrical
Equipment (WEEE). If this product is contaminated, this directive does not apply.
For more specific disposal information, see www.welchallyn.com/weee, or contact Welch
Allyn Customer Service at +44 207 365 6780.
DISPOSING OF BATTERIES
Dispose of used batteries properly. Consult your local recycling authority for proper
procedures.
DISPOSING OF PROBE COVERS
Ensure that probe covers are disposed of according to facility requirements or local
regulations.
Caution DO NOT use hard or sharp objects to clean the probe well. This could
damage the probe well and cause the unit to not function properly.
Caution DO NOT use steam, heat, or gas sterilization on the probe well.
Caution DO NOT autoclave the probe well.
To Next Page
Loading...
Need help?
General
