Directions for use 17
6. Hold the thermometer in place for the required duration:
7. Record the temperature before removing the probe from the site.
8. Eject the probe cover by firmly pressing the ejection button on the top of the probe.
9. Replace the probe in the probe well to clear the display and reset the thermometer to
Normal Mode. The thermometer will not beep to indicate a final temperature.
Instrument Security
The SureTemp Model 692 thermometer is equipped with electronic security options
designed to reduce the risk of theft. These options include both Temperature Count and
Instant-On security features.
TEMPERATURE COUNT
The Temperature Count security feature allows you to take a set number of temperature
readings before the instrument goes into the security alarm state. The selectable counts
are 25, 50, 100, and 200. As the instruments nears the final reading, it will display
SECURITY COUNT as a warning, along with a number representing the last 5
temperature counts (i.e., 5,4,3,2,1) remaining on the security counter.
When the instrument enters the alarm state, it beeps for approximately 10 seconds. At
this time, the instrument displays SEC on the LCD along with SECURITY COUNT in the
ID field in the upper left-hand corner of the screen. The instrument is then disabled.
Returning the instrument to the wall holder resets the security count. If the count is set to
“OFF” the temperature count function is disabled and no security alarm will occur.
To set the Temperature Count security feature, please refer to the Service Manual.
INSTANT-ON
When the Instant-On feature is activated, the instrument goes into the security alarm
state within five seconds after removal from the wall holder. When the instrument enters
the alarm state, it beeps continuously and displays SEC on the LCD. Pressing the Mode
Selection button while removing the probe from the probe well, within 30 seconds of the
instruments removal from the wall holder, clears the alarm and allows the instrument to
operate. Returning the instrument to the wall holder will reset the instant audio alarm.
The options for the Instant-On feature are ON and OFF. In the OFF setting, no security
alarm will sound.
To set the Instant-On security feature, please refer to the Service Manual.
Oral 3 minutes
Axillary 5 minutes
Rectal 3 minutes
WARNING Long-term continuous monitoring beyond three to five minutes is
not recommended in any mode.
To Next Page
Loading...
Need help?
General
