i16 Manual Page 35 - Revision: 2-09-2023
STEP 4: Rinsing Operation
14. Spray the inside of the tank with hydrogen peroxide (HO) and wipe out a clean paper towel.
HO should be approximately 20% HO to 80% water blend.
15. Pour 4L of clean water into the Ice Tank for rinsing operation.
16. Exit the “Cleaning Mode” by pressing the Hot Water Selection Button for 5 seconds.
17. Re-enter the “Cleaning Mode” by pressing the Hot Water Selection Button for 5 seconds
(for Rinsing Operation). *Caution: Ice making operation starts 5 minutes after exiting
“Cleaning Mode,” so it is important to re-enter “Cleaning Mode” within 5 minutes to
prevent any ice-making during the sanitizing process.
18. Run the rinsing operation for 5-10minutes, then drain the water through the Drain Valve
and Hot Water Drain Valve. *In the case that the dispensed water has an unusual taste or
odor, it is recommended to repeat the rinsing operation again.
19. Exit the “Cleaning Mode” by pressing the Hot Water Selection Button for 5 seconds.
STEP 5: Cleaning the Reservoir Tank
20. Clean the Reservoir Tank with a clean, soft cloth.
STEP 6: Product Re-Assembly
21. Attach the White Ice Holding Basket and reinstall the 2 augers to original location. *Make
sure to insert the tips of the spiral tightly into the fastening groove.
22. Assemble the Ice Tank cover and Front Cover and open the water supply valve to feed water
to the unit.
23. Ensure that the unit is making ice and dispensing ambient water.
24. Verify that water is dispensing from the hot tank before turning the Hot Tank Switch
back on. If water does dispense from the Hot Tank, turn the Hot Tank Switch on.
25. Assemble the Top Cover and Water Tray.
To Next Page
Loading...