WELLTECH ATA-171 - V2.0 - Using CLI command to configure the ATA; CLI command list

ATA-171/172/171P/171M (ATA-S1/S2/P/M)
User’s Guide
51
(3-1) ipconfig –ifN function
Æ
N is 0, 1, 2
Index Command Description
1 ? Show 'ipconfig -ifN' Option
2 -t Set Host Type
3 -m Set MAC Address
4 -i Set IP Address
5 -nm Set Net Mask
6 -g Set Gateway
7 -dns0 Set Primary DNS server
8 -dns1 Set Secondary DNS server
9 -dr Set Default Route
10 -nat Set NAT
11 on Enable Interface
12 off Disable Interface
13 -dhcps DHCP Server Setting
14 -ddns Set DDNS
15 -bridge Set Bridge
16 -dev0 Set Device 0 Setting
17 -dev1 Set Device 1 Setting
18 -dev2 Set Device 2 Setting
19 (null) Show Interface Setting
-4- save function
Index Command Description
1 ? Show 'save' Option
2 -book Save phone book
3 -sys Save system setting
-5- reboot function is to restart the system.
-6- exit function is to exit the CLI.
-7- debugmode function is to enter the debugmode.
-8- update function
Index Command Description
1 ? Show 'update' Option
2 -os Update OSImage(IP filename)
3 -dsp Update DSP Image(IP filename)
4 -all Update All Image(IP filename)
5 -server Update Server (IP filename length)
6 -pcm PCM(IP filename)
-alaw alaw (IP filename)
-ulaw ulaw (IP filename)
-g729 g729 (IP filename)
-g726.16 g726.16 (IP filename)
-g726.24 g726.24 (IP filename)
-g726.32 g726.32 (IP filename)
-g726.40 g726.40 (IP filename)
IP is the TFTP server’s IP address, and the filename is the image you want to download into the
system.