Weltem Americool HPC-3000 - Page 5

page 5
Owner’s Manual
HPC-3000 / WPC-4000 / HPC-5000 / WPC-7000 / WPC-9000 / WPC-15000
16. Always turn the unit o and unplug the main power plug from the electrical
outlet before cleaning, moving, or performing maintenance.
17. AVOID the use of adapter plugs or extension cords. If it is necessary to use an
extension cord or an adapter plug to operate the unit, ensure that they are
correctly rated for the applicaon. Consult local qualied electrician and all
local electrical codes to ensure proper setup. Any extension cord used with
the device must be rated for a minimum of 15A.
18. DO NOT unplug the unit by pulling on the electrical cord. Keep the electrical
cord away from heat sources and always completely unroll the cord to avoid
overheang. If the power cord becomes damaged, a qualied service agent,
qualied electrician, or similarly qualied person must replace it, in order to
avoid a hazard or shock.
19. The lters must be used with the product at all mes. When the lters are
removed for cleaning, always ensure that the unit has been turned o and
unplugged from the electrical outlet.
20. Regularly clean the lters to maintain eciency. If the lters are not cleaned
regularly, the units output performance and eciency will decline and en
-
ergy consumpon will increase.
21. DO NOT operate the unit with a damaged power cord or plug, aer it mal
-
funcons, or if the unit has been dropped or damaged.
22. Only use the unit in the upright posion on a even, at surface. Unit must be
posioned at least 24 inches (60 cm) from the nearest object in any direc
-
on.
23. Stop operaon immediately if abnormal noise or odor is noced. Contact
local service center.
DO NOT operate a unit with a damaged power cord
WARNING