SPECIFIC RULES FOR TRACK SAWS
14. Make sure the blade you are using is the correct type for the material being cut. Do not cut logs or shrubbery
with this saw. Only cut flat workpieces.
15. Always make sure that the cutting path, including underneath the workpiece, is free of obstructions before cut-
ting, particularly during plunge cuts.
16. Always adequately support the workpiece.
17. Never use damaged or incorrect blade washers or bolts. The blade washers and bolts were specially designed for
your saw with optimum performance and safety of operation in mind.
18. Do not leave the tool running. Operate the tool only while holding it in your hands.
19. When operating the tool from an elevated position, be aware of people or things beneath you.
20. Always hold the tool firmly in your hands before switching the tool “ON.” The reaction to the torque of the
motor as it accelerates to full speed may cause the tool to twist.
21. Wear eye and hearing protection. Always use safety glasses with side shields. Everyday glasses provide only lim-
ited impact resistance unless otherwise specified. They are not safety glasses. Only use certified safety equipment.
Eye protection equipment should comply with ANSI z87.1 standards. Protective hearing equipment should comply
with ANSI s3.19 standards.
22. Protect your lungs. Wear a face or dust mask if the operation is dusty. Following this rule will reduce the risk of
personal injury.
23. These instructions can’t possibly warn of every scenario that may arise with this tool, so always make sure to use
common sense during operation.
WARNING: Read and understand all warnings, cautions and operating instructions before using this
equipment. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
6
To Next Page
Loading...
Need help?
General
