5
SPECIFIC RULES FOR TABLE SAWS
9. REMOVE ALL ACCESSORIES FROM THE TABLE. Before transporting the saw, remove all accessories
(miter gauge, rip fence....). Failure to do so can result in an accident causing possible serious personal injury.
10. NEVER USE RIP FENCE AS A CUT-OFF GAUGE when crosscutting. Move the rip fence out of the way.
11. NEVER ATTEMPT TO FREE A STALLED BLADE without first turning the saw OFF. If a work piece stalls
the blade, turn the saw off and unplug it for both safety and also damage prevention to the motor.
12. PROVIDE ADEQUATE SUPPORT to the rear and sides of the table saw for wide or long workpieces.
13. AVOID AWKWARD OPERATIONS and hand positions where a sudden slip could cause your hand to
move into the spinning blade.
14. MOUNT YOUR TABLE SAW on the supplied stand or to a work bench before performing any cutting opera-
tions.
15. NEVER CUT METALS or materials that may make hazardous dust.
16. ALWAYS USE A PUSH STICK, especially when ripping narrow work piece. One is supplied with this saw.
To Next Page
Loading...
Need help?
General
