19
WARNING: Always turn the switch OFF and unplug the power cord from the outlet before maintaining
or lubricating the scroll saw.
To ensure that the wood glides smoothly across the work surface, periodically apply a coat of paste wax
(sold separately) to the surface of the worktable. If the power cord is worn out or damaged in any way,
replace it immediately. Do not attempt to oil the motor bearings or service the motor’s internal parts.
LUBRICATION (Fig. 21)
Lubricate the arm bearings after every 50 hours of use.
1. Turn the saw on its side and
remove the cover.
2. Squirt a generous amount of
SAE 20 oil (lightweight motor oil,
sold separately) around the shaft
and bearing.
3. Let the oil soak in overnight.
4. Repeat the above procedure for
the opposite side of the saw.
BLADES
To maximize the life of your scroll saw blades:
1. Do not bend blades when installing.
2. Always set proper blade tension.
3. Use the right blade (see instructions on replacement blade packaging for proper use).
4. Feed the work correctly into the blade.
5. Use thin blades for intricate cutting.
CAUTION: Any and all servicing should be performed by a qualified service center.
MAINTENANCE
FIGURE 21
To Next Page
Loading...
Need help?
General
