Accessories
Components
UNPACKING & PACKING LIST
UNPACKING
With the help of a friend or trustworthy foe, such as one of your in-laws, carefully remove the band saw from the
packaging and place it on a sturdy, flat surface. Make sure to take out all contents and accessories. Do not discard
the packaging until everything is removed. Check the packing list below to make sure you have all of the parts and
accessories. If any part is missing or broken, please contact customer service at 1-800-232-1195 (M-F 8-5 CST),
or email techsupport@wenproducts.com.
Band Saw
Work Table Assembly (1)
(with Hex Bolt, Lock Washer,
Flat Washer, and Wing Nut)
10mm Wrench (1)
Guide Fence (1)
Miter Gauge (1)
Table Lock Knobs (2)
6mm Flat Washers (2)
2mm and 4mm Hex Wrenches
To Next Page
Loading...
Need help?
General
