Wen 3962 User Manual

INSTALLING THE GUIDE RAIL (FIG. 5)
1. Install the 4 guide rail lock knobs (A) into the underside
of the table. Do not tighten them yet – just seat them in the
holes.
2. With the ruler-side up, slide the slots on the guide rail (B)
over the threaded shafts of the knobs. Tighten the knobs.
INSTALLING THE FENCE (FIG. 6)
1. Lift the fence locking lever (A) to unlock it.
2. Slide the fence (B) onto the guide rail.
3. Lower the fence locking lever to lock it in position.
REVERSING THE FENCE (FIG. 7)
The rip fence can be used on either side of the blade. If us-
ing it on the right-hand side of the blade, reverse the fence
by following the instructions below.
1. Remove the knobs (A) and washers (B) from the fence
assembly.
2. Reverse the fence beam (C).
3. Re-install the knobs (A) and washers (B) onto the fence
beam bolts (D). Tighten the knobs.
ASSEMBLY & ADJUSTMENTS
12
NOTE: When cutting thin materials, the fence may be
re-positioned further. See Fig. 8. Remove the knobs
(A) and washers (B) from the fence assembly. Flip the
fence so the flat side faces down. Remove the fence
beam bolts and re-install them in the bottom slot (C).
Re-install the knobs and washers onto the fence beam
bolts. Tighten the knobs.
NOTE: The locking handle is spring-loaded and can be
re-positioned. To re-position the handle, pull the handle
body outwards, turn it to the desired position, then let
it spring back in.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
BEVELING THE TABLE (FIG. 9, P. 13)
1. Loosen the table bevel lock handle (A). Adjust the table
to the desired position.
2. Use the angle indicator (B) to confirm the desired angle,
then tighten the table bevel lock handle.
A
A
A
A
B
B
C
C
D
B
B
B
A

Wen 3962 Specifications

General

Motor	3.5 Amp
Weight	42 lbs
Type	Band Saw
Blade Diameter	Not Applicable
Arbor Size	Not Applicable
Table Size	14-1/4" x 12-1/2"
Max Cutting Depth at 45°	Not Applicable