UNPACKING
With the help of a friend or trustworthy foe, carefully remove the band saw from the packaging. Make sure to take
out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list
below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact our
customer service at 1-800-232-1195 (M-F 8-5 CST), or email techsupport@wenproducts.com.
PACKING LIST (NOTE: A hardware bag is included but not shown below.)
ASSEMBLY/ADJUSTMENT TOOLS (NOT INCLUDED)
The tools listed below are required for either assembly or adjustment:
• 14mm Open-End Wrench (2)
• Phillips-Head Screwdriver (1)
UNPACKING & TRANSPORTATION
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
9
Band Saw &
Table (1)
Guide
Rail (1)
Legs (4)
Miter Gauge
(1)
Long
Brace (2)
Short
Brace (2)
10/13mm
Wrench (1)
Hex Wrench
(4)
Rip
Fence (1)
Knob (4)
Hardware Bag Contents
• Carriage Bolts, M8 x 16 (16)
• Flat Washers, 8mm (16)
• Hex Nut, M8 (16)
• Hex Bolts, M6 x 10 (4 - with table)
• Flat Washers, 6mm (4 - with table)
Foot (4)
• Combination Square (1)
• Bubble Level (1)
TRANSPORTING
When transporting your band saw, never carry the saw by its guards or its accessories.
To Next Page
Loading...
Need help?
General
