35
INTRODUCTION
Stagehand platform units are available in two fixed elevations (16" and 24"), as well as two dual-height
options (16/24" and 24/32").
Easily-attached 39" wide stairway units with double handrails are available in a 2-step version (for 16" or
24" stage heights) and a 3-step version (for 24" or 32" stage heights).
Guard rail assemblies should be used with all stage elevations, and are available in 3', 4', 6' and 8'
lengths. The to rail on all guard rails is located 42" above the platform surface. The rail assemblies
include a chair stop rail.
To give the stage a more formal, finished look, drapery skirting and drapery backdrops are also available
from Wenger.
UNPACKING OR SETTING UP FOR THE FIRST TIME
1. Remove all parts from their shipping cartons (refer to the packing list enclosed with the shipment).
Save the packaging materials at least until the stage system has been set up the first time.
2. Sort all platform units and accessories by size, leg length, etc.
3. Assemble all carts and stairways that are shipped disassembled - using the instructions supplied
with them.
4. If the platform units will be stored before being set up, see “Transporting and Storing Platform Units”
on page 43 and “Disassembling the Platform System” on page 42.
If the platform units will be set up immediately, see “Setting Up Individual Platform Units” on page 36.
IMPORTANT: Read this entire manual before you start to set up a platform system.
!
WARNING
Do not set up a
multilevel stage
using Stagehand
units.
To Next Page
Loading...