44
MAINTENANCE
STAGE
SURFACE
Stagehand platform units are available with the following surfaces:
• hardboard
• skid-resistant
• carpeted.
Clean and protect hardboard surfaces as you would any normal flooring. Clean skid-resistant surface by
sweeping with a broom. Spot-clean carpeting, keeping it as dry as possible — never saturate the carpet.
DRAPERY
ENCLOSURES AND BACKDROPS
Drapery sections may be washed or dry-cleaned. Remove all drapery clips prior to cleaning.
Machine-wash at 120° F or lower using mild detergent. Remove immediately after the wash cycle is
completed.
Tumble-dry at “permanent-press” or lower temperature. Remove and hang immediately to prevent
wrinkling. Excessive heat or drying time will detract from the permanent-press characteristics of the
fabric.
Little or no ironing is required.
When dry-cleaning, tumble-dry on the lowest heat cycle and remove immediately when dry.
GAS SPRINGS
If you suspect that the gas springs on the cart are not operating properly, contact the Customer Service
department at Wenger Corporation immediately. NEVER use the platforms that have faulty springs!
O
THER PREVENTIVE
MAINTENANCE
Inspect all bolts on the stage and accessories every six months, and tighten as necessary.
Replace any worn, bent, or broken parts promptly to prevent injury.
REPLACEMENT PARTS LIST
Replacement parts for your Trouper Platform System can be ordered from Wenger Corporation by:
Phone: USA, (800) 733-0393
International, (507) 455-4100 collect
Fax: (507) 455-4258
Mail: The Wenger Corporation
P.O. Box 448
555 Park Drive
Owatonna, Minnesota, USA 55060-0448
When ordering replacement parts, always indicate the product name and model.
Items not shown on the following pages:
When ordering additional backdrop or enclosure draperies, indicate height, width, and color.
Replacement parts are not available for the basic platform units: order complete new units.
To Next Page
Loading...