WerkMaster Cobra - Changing Tools; Adjusting the Dust Skirt

OPERATOR’S)MANUAL))
Page!8!)
!
O) ! ! ! ! ! ! ! ! ! ! )A))
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! J!
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
F) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) B)
! ! ! ! ! ! ! ! ! ! ! !
E) ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! H))
)
) ) ) ) ) ) ) ) ) ) ) )N) ) ) ) ) )
D)
!
) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) K)
! ! ! ! ! !
!
!
!
!
Fig.!4! ! ! ! ! ! ! ! ! ! ! ! ! Fig.!5!
!
1. Unplug the power cord from the twist lock inlet (C).
2. Ensure the handle is in its full upright position (Fig 2). Tilt the machine back
(Fig 3).
3. Choose the appropriate tooling holder attachment – magnetic Plug ‘N Go plate
(D) (Fig 4) for Metal Bond tools or Foam/Hook and Loop Adapter plate for
polishing resins and sanding pads.
4. Insert the two shear pins (N) through the compression foam pad (E) into the
rubber grommets on the pad driver (F). Attach the tooling to the plate.
4. Return the machine to the upright position (Fig 2).!
!
The dust skirt (G) serves as a seal for the bottom of the machine acting as a
vacuum chamber helping the dust stay contained under the machine. If the skirt
is too far from the ground, the dust containment is reduced.
To adjust the skirt:
1. Remove loop retaining strap (L)
2. Pull one end of the skirt off the front of the machine until you reach the middle
of the skirt at the rear of the drive train,
3. Position the skirt until it is barely touching the ground and repeat with the other
end.
4. Pull the skirt snug. The two ends of the skirt should not touch. You may have a
gap of up to one inch. Replace the loop retaining strap.
!!
!
Avoid positioning the skirt too low as it will drag against the ground, wearing the
skirt out prematurely and possibly preventing smooth machine movement.
Changing Tools
)
Adjusting the Dust Skirt
! ! ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! ))CAUTION)