WerkMaster Cobra - Generator Requirements; Introduction to Controls; Machine Controls Overview; VFD Control Functions

OPERATOR’S)MANUAL))
Page!7!)
!
!
The minimum generator requirement for the COBRA is 6 kW.!!
!
!
!
!
Exercise extreme caution at all times when working with electrical power.
WerkMaster strongly recommends that only certified electricians be permitted to
work with electrical power sources within a customer’s facility or on their job site.
INTRODUCTION TO THE CONTROLS
!
All machine operating controls are found on the handle NOT on the keypad of the
VFD.
The VFD controls are locked out to avoid accidentally changing necessary
parameters.
MACHINE OPERATION
)
)
ALWAYS turn off and disconnect power from the machine when performing any
operations to the bottom of the machine. The machine and the tooling may be
hot after using.
!
! ! ! ! ! ! ! ! ! !! ! ! ! ! A! ! ! ! ! D)
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! J))) )
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ) ) )))) ) ) ) )
!
C))) ) ) ) ) ) ) ) ) ) I)
! ! ! ! !!!!
!
! ! ! ! ! M)
!!!!!!!!! ! ! ! !!!
!!!!!!!!!!! ! ! ! !
! !
!
!
! ! ! ! ! L! ! ! ! ! ! ! ! G)
!
Fig.!1! ! ! ! ! ! ! ! !!!Fig.!!2! ! ! ! ! !!!!!!!!!!!!!!!!!!!!!!!!!!Fig.!3!
!
!
!
!
!
!
!
Generator
Minimum Requirements
Machine Controls
VFD Controls
! ! ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! )WARNING)
! ! ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! )WARNING)
!