Westerbeke 6.5KW - Page 9

It is wiser that special rigging work be done by experienced and
competent people knowledgeable in the handling of heavy equipment.
Extreme caution and care cannot be stressed enough.
Generator Mounting - Location
The complete generator unit is mounted on lightweight rails
through soft flexible isolator mounts that prevent the transfer of
vibration from the generator to the rails. Three 1/2 inch bolt holes
are in each generator mounting rail to be used in properly secur ing
the generator to its mounting platform. These holes are on 15 inch
mounting centers.
The location should be such that it is dry and above low-lying
vapor areas and away from being splashed by bilge water or water from
above. It should be properly ventilated and accessible for minor ser-
vicing and repairs. Access for major repairs should be given con-
sideration as well. The location should be properly ventilated. The
platform on which the generator is mounted should be strong enough to
support the generator and securely hold the mounting rails fastened to
it at all angles of vessel operation.
The generator set needs fresh cool air in whatever location in the
vessel it is installed. Air is needed for combustion wi thin the
engine cylinders and is of prime importance for cooling the generator
end. Heat from the generator end must be removed to insure proper
generator efficency and longevity.
5