• Acknowledge that you wish to conduct the factory reset by unplugging the Ethernet
cables. The ON LED will stop flashing. This initiates the factory reset process, and after
approximately 1 minute the product will restart with factory default settings. When the
product has booted up, the ON LED will show a green light, and is now ready to use.
To boot as normal:
• To skip the factory reset process, just wait for approximately 30 seconds (after the ON
LED starts flashing RED) without unplugging the Ethernet cables. The product will
conduct a normal boot with the existing settings.
22 Lynx L110-F2G & L210-F2G
To Next Page
Loading...
