12 | English
MUFFLER AND SPARK ARRESTOR
The spark arrestor prevents sparks from exiting the mufer.
It must be removed for servicing.
NOTICE
The spark arrestor is a safety device
that prevents sparks from exiting the mufer and cre-
ating a re hazard. In certain locations a spark arrestor
may be required by law. It is the operator’s responsi-
bility to know and follow all local laws and regulations
related to re prevention requirements.
OIL DIPSTICK
Unscrew the oil dipstick to check oil levels and add oil when
needed.
OUTPUT READY LED
Illuminates when the generator is operating normally. In-
dicates the generator is producing electrical power at the
receptacles.
OVERLOAD LED
Indicates that the generator is overloaded.
COMPONENTS
A - 120 Volt AC 20 A receptacles
B - Ground terminal
C - Parallel operation outlets
D - Data center
E - Reset button
F - USB ports
G - Low oil LED
FIG. 7
OVERLOAD RESET
The generator will automatically switch OFF all AC output
to protect the generator if overloaded or if there is a short
circuit in a connected appliance.
PARALLEL OPERATION OUTLETS
A parallel cord (not included) can be used to connect a
compatible Westinghouse inverter generator for additional
power output.
RECOIL HANDLE
Use the recoil handle (and the engine/fuel control switch)
to start the generator.
SPARK PLUG SERVICE DOOR
Lift the spark plug service door to access the spark plug.
USB PORTS
Two-ports 5V/2.1A USB outlet. Accepts Type A USB plugs.
H - Overload LED
I - Output ready LED
J - Fuel selector
K - LPG/Propane inlet
L - Battery charger
M - Battery indicator
N - ECO mode switch
O
- Electric start button
P - Battery switch
Q - Main circuit breaker
R - 20 A circuit breaker
S - 30 A circuit breaker
T - 120 Volt AC 30 A receptacle
A B C
D
E
H
F
I
G
NP M K JO L
R
S
Q
T
To Next Page
Loading...
