Glasstilt Rev. 2.0 (202202)
Operating instructions
32
4.1.2 Preparations before filling
Check and fit:
• That the machine and removable parts are complete and have been
cleaned. If not – clean them
• That no dirt is in the wash arms’ (17) or in the rinse pipes’ (15) nozzles
• That removable parts are in place, level pipe (12), tank filter and cover
plates (13).
• The rubber sleeve (11) must seal against the base plate.
• Including drain filter on machines with a drain pump (22)
• On DUPLUS machines: filter for recirculating rinse (23)
• Check that the lower washing arm (16) can rotate freely
• The amount of detergent and drying agent
• That the stopcock for the water to the machine is open
• That the power switch is in the ON position
To Next Page
Loading...
