Wheaton UniSpense PRO - Unit Setup and Configuration; Unit Reset and Dispense Preparation

WHEATON UniSpense
®
PRO Peristaltic Pump
WHEATON | 800.225.1437 (U.S. & Canada Only) | 856.825.1100 | www.wheatonsci.com| P/N 50099073 Rev. 2/2/10 Lit. No.8734
11
8.1 Language Selection
Press the UP and DOWN and the LEFT and RIGHT keys to access the Language Selection. Help
screens are available in the following languages: English, French, German, Spanish, Japanese, Chinese,
and Korean. Press OK when done.
8.2 Buzzer Function
Press the UP and DOWN and the LEFT and RIGHT keys to access the Buzzer Function.
Turning the buzzer function ON will cause the unit to sound an end-of-dispense alert. Turning the buzzer
function OFF (shown) will disable the buzzer during the dispense cycle.
8.3 Unit Reset
Press the UP and DOWN and the LEFT and RIGHT keys to access the Unit Reset Function.
WARNING! – Resetting the unit will return the unit to factory setup parameters. It will NOT clear any
settings stored in memory.
To reset the unit, highlight the ‘check’ mark, and press OK. A special tone will sound when the unit resets.
9.0 Preparing for Batch and Single Dose Dispensing
Press the OK button to transition to the HOME screen. Set the tubing size by pressing the UP and
DOWN keys to move to the tubing icon. Use the LEFT and RIGHT arrows to navigate the number fields,
and the UP and DOWN icons to adjust the number fields. Press the OK button when done.