Whirlpool KRFC704FSS - Page 28

For Service Technician Use Only
DIAGNOSTICS
1-24
n
French-Door Boom Mount Refrigerator

• Show XX for 1 second (version format XX YY ZZ)
• Blank for 0.5s
• Show YY for 1 second (version format XX YY ZZ)
• Blank for 0.5s
• Show ZZ for 1 second (version format XX YY ZZ)
• Keep Blank When Complete

• Show XX for 1 second (version format XX YY ZZ)
• Blank for 0.5s
• Show YY for 1 second (version format XX YY ZZ)
• Blank for 0.5s
• Show ZZ for 1 second (version format XX YY ZZ)
• Keep Blank When Complete

• When entering Service Test, the numeric display shows the
current Proximity Sensor Acvaon mode.
• “00” indicates no movement.
• “01” indicates movement of object/person.
• To advance between control mode use “+” or “-” key. Once
desired seng is selected, push “Drawer” key to acvate then
“Max Cool” to exit this mode.

• When entering Service Test, the numeric display shows the
current Heater Acvaon mode.
• “00” indicates heater controlled by measured humidity.
• “01” indicates heater always on.
• To advance between control mode use “+” or “-” key. Once
desired seng is selected, push “Drawer” key to acvate then
“Max Cool” to exit this mode.

• When entering Service Test, the numeric display shows the
current Heater Acvaon mode.
• “00” indicates heater controlled by measured humidity.
• “01” indicates heater always ON.
• To advance between control mode use “+” or “-” key. Once
desired seng is selected, push “Drawer” key to acvate then
“Max Cool” to exit this mode.

• When entering Service Test, the numeric display shows the
current Heater Acvaon mode.
• “00” indicates heater controlled by measured humidity.
• “01” indicates heater always ON.
• To advance between control mode use “+” or “-” key. Once
desired seng is selected, push “Drawer” key to acvate then
“Max Cool” to exit this mode.