Whirlpool KRFC704FSS - Dispenser UI and Component Access

COMPONENT ACCESS
French-Door Boom Mount Refrigerator
n
3-9
Dispenser User Interface (UI) and Dispenser Components

1. Depress the two tabs under the front of the UI.
2. Remove the ve wiring connectors from the UI. Remove the
UI panel.

3. Push in the drip tray fully. Li the front edge and remove the
drip tray.
4. Remove the two 1/4" screws in the dispenser tray slide.
5. Remove the two 1/4" screws in the top of the false wall.
6. Unclip the dispenser water tube from above the water
paddle.
7. Slide the false wall forward and remove from the dispenser
housing.

8. Note the posioning of the water paddle torsion spring and
remove.
9. Disengage the water paddle from the two plasc retaining
clips and remove.

10. Disconnect the wiring connector from the water paddle
switch.
11. Remove the switch from the plasc clips holding it in place.

1. Remove the UI.
2. Remove the false wall.
3. Note the posioning of the ice paddle torsion spring and
remove it.
4. Remove the two plasc ice paddle pins from the holes in the
plasc housing and remove ice paddle.

1. Remove the UI.
2. Remove the False Wall.
3. Disconnect the wiring connector from the ice paddle switch.
4. Remove the switch from the plasc clips holding it in place.

1. Remove the UI.
2. Remove the False Wall.
3. Remove the two 1/4" screws holding the ice door.
4. Motor Bracket in place, and remove.

1. Remove the UI.
2. Remove the false wall.
3. Remove the ice door motor bracket.
4. Disconnect the wiring connector for the dispenser heater.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.