GB
Quick Guide
CONTROL PANEL
Before using the appliance carefully read the Safety Instruction.
Before using the machine, it is imperative that the transport bolts are removed.
For more detailed instructions on how to remove them, see the Installation Guide.
DETERGENT DISPENSER
Compartment 1: Pre-wash detergent
(powder)
Compartment 2: Washing detergent
(powder or liquid)
Compartment 3: Additives (fabric softeners,
etc.)
The fabric softener must not exceed the “MAX”
level.
! Use powder detergent for white cotton
garments, for pre-washing, and for washing at
temperatures over 60°C.
! Follow the instructions given on the detergent packaging.
1
2
3
PRODUCT DESCRIPTION
1. Worktop
2. Detergent dispenser
3. Control panel
4. Door handle
5. Door
6.
7. Adjustable feet (4)
1.
3.
2.
5.
4.
6.
7.
1.
2. Programme selector
3. Start/Pause button
4. Temperature button
5. FreshCare+ button
6. Dry Only button / Lock button
7. Drying settings button
8. Display
9. Start delay button
10. Spin speed button
21
9
3
4
10
6
5
7
8
DISPLAY INDICATORS
Washing phase
Indicates washing phase of the cycle
Drying phase
FreshCare+ activated
Key lock activated
Drying only
Timer drying mode
Drying automatic levels
Start delay activated
Door locked
* Select the programme and set the spin speed to “0“ to drain only.
The cycle duration indicated on the display or in the manual is an estimated time calculated for
such as inlet water temperature and pressure, ambient temperature, quantity of detergent, size
and type of load, load balancing and any additional optional functions selected.
6th Sense - the sensor technology adapts water, energy and programme duration to your
wash load.
For wash programmes with temperatures above 50°C, we recommend using powder
detergent rather than liquid, and following the directions given on the detergent package.
For all Test Institutes
1) Test programme in compliance with standard EN 50229 (Wash): select the “
”
programme with a temperature of 60°C.
2) Long cotton programme: set the “ “ programme with a temperature of 40°C.
3) Synthetic program along: set the “
“ programme with a temperature of 40°C.
Test programme in compliance with standard EN 50229 (Drying): select the “
“ wash
programme and set the drying level to “
carried out with the nominal load.
Max. spin
Max. load
Max. load