9
CLEANING AND MAINTENANCE
CLEANING THE OUTSIDE OF THE WASHER-DRYER
Use a soft damp cloth to clean the outer parts of the washer-
dryer.
Do not use glass or general purpose cleaners, scouring
powder or similar to clean the control panel – these
substances might damage the printing.
CHECKING THE WATER SUPPLY HOSE
Check the inlet hose regularly for brittleness and cracks. If
damaged, replace it by a new hose available through our
After-Sales Service or your specialist dealer.
Depending on the hose type:
If the inlet hose has a transparent coating, periodically check
and should be replaced.
For water stop hoses: check the small safety valve inspection
window (see arrow). If it is red, the water stop function was
triggered, and the hose must be replaced by a new one.
For unscrewing this hose, press the release button (if
available) while unscrewing the hose.
CLEANING THE MESH FILTERS IN THE WATER SUPPLY HOSE
1. Close water tap and unscrew the inlet hose.
1
2
2.
3. Now unscrew the inlet hose on the back of the washer-
dryer by hand. Pull out the mesh lter from the valve
on the back of the washer-dryer with pliers and
carefully clean it.
4.
water tap and washer-dryer again. Do not use a tool
to connect the inlet hose. Open the water tap and check
that all connections are tight.
2
1
washer-dryer.
washer-dryer.
To Next Page
Loading...
