Whirlpool WHER25 - Install RO Faucet and Electronics; Select RO Faucet Mounting Location

Step E - Install RO Faucet
13
You will need to select the location of the Reverse
Osmosis Faucet. You have three options to choose
from:
•Usetheexistingsinktopholeforthesprayhose
orsoapdispenser (Must be 1-3/8” in diameter)
•Drillanewholeinthesink
•Drillanewholeinthecountertopnexttothe
sink
1. Determine where you are going to install your
Reverse Osmosis Faucet.
2. Check to ensure the Reverse Osmosis faucet will
mount flat against the mounting surface.
3. Visually review the routing of the tubes from the
Reverse Osmosis filter assembly to the faucet.
Check to ensure there is adequate tube routing
space between the faucet and filter assembly.
4. If drilling is needed, drill a 1-3/8" diameter hole in
the mounting surface.
IMPORTANT:Drillingholesintocountertopsand
sinksshouldonlybeperformedbyaninstaller
whoisqualifiedfordrillingsuchmaterials.
Drillingofsurfacesmadeofstoneorsolidsur-
facematerialssuchasgranite,marble,Corian™
orotherplasticresinproductsorsinksmadeof
porcelainorstainlesssteelmaycauseperma-
nent,irreparabledamagetothesinkorcounter-
topsurface.
FIG.14
SELECTLOCATIONOFREVERSEOSMOSIS
FAUCETMOUNTINGHOLE
Questions?CallTollFree1-866-986-3223 Monday- Friday, 8 AM - 7 PM EST
orvisitwww.whirlpoolwatertreatment.com
When you call, please be prepared to provide the model, date code and serial number,
found on the rating decal, located inside the cover.