Whirlpool WHER25 - Page 3

3
Thingstoremember!
=
It will take time before water is available at the
faucet. It may take 1-4 hours before maximum
possible flow is available from the faucet.
= Water pressure from the Reverse Osmosis faucet
will be less than your standard faucet due to the
high level of filtration performed by the system.
= The faucet can be mounted in an existing hole in
the sink (sprayer, soap dispenser etc.) or a new
hole can be drilled.
= Water will run to the drain while the Reverse
Osmosis system is producing purified water, even
if you are not drawing water from the faucet. You
may hear a small quantity of water going to the
drain whenever the system is producing purified
water. Water going to drain will automatically
shut off when the storage tank is full.
= This unit can be installed remotely (basement,
mechanical room) or under the sink.
NeedHelp?
Calltollfreeat:
1-866-986-3223
8:00 a.m. - 7:00 p.m. EST M-F