Page 14
XLTP 041612
Drain Line
All units come with a drain line for additional removal of exces-
sive condensate. It is mandatory to install the drain line with “T”
fitting. During operation, the cooling unit will strip excess
water from the air in order to maintain the proper level of
humidity within the cellar. However in extreme humidity, addi-
tional condensate will be removed. Thus the drain line will pre-
vent overflow and leaking by allowing for discharge of the
additional condensate.
Failure to install the drain line voids the warranty.
To prevent mold from growing, allow the drain line
to hang above the water line.
Condensation Drain Line Tube
The condensation drain line tube is used to remove excess condensation from the unit to a proper discharge location.
It is important that the drain line tube is properly connected and used to prevent leakage and other problems associ-
ated with excess condensation.
Failure to use the condensation drain line tube will void the warranty on the unit.
WRONG: Drain line is under water.
DRAIN LINE
To Next Page
Loading...
Need help?
General
