Page 15
LIQUID MEASURING THERMOSTAT SYSTEM
The WhisperKOOL Series cooling units come equipped with a liquid temperature measuring thermostat system. This
system incorporates the following advantages:
Self-Calibrating Probe
The probe contains a sensor chip, which actually communicates back and forth to the thermostat. This results in a
consistent temperature setting and accuracy.
Measuring liquid temperature has a few unique advantages:
1. Wine temperature is kept in a very precise controlled environment. This assures a consistent temperature.
2. By measuring the liquid temperature rather than air, the unit will operate 75- 80% of the time.
Liquid Measuring Thermostat System
To assure a consistent temperature, place bottle probe approximately 3 feet away from the air output and not in the flow of the air.
To Use the thermostat:
1. Locate an empty wine bottle.
2. Fill 3/4 full with room temperature tap water.
3. Place bottle probe securely into bottle making
4. Place bottle with probe level and to the side of the unit in your wine cellar.
It is recommended that it is placed in a central location of your wine cellar.
Avoid pulling too much on the probe cord. It may become disconnected
resulting in non-operation of the unit.
Note: The thermostat can be set between 50°F and 70°F.
Remember: The WhisperKOOL Unit is based on the temperature of the water.
Do not be misled by thermostats reading air temperature. The air temperature
in the cellar will be cooler than the liquid temperature of the wine while it is
coming to optimum balanced temperature.
To Next Page
Loading...
Need help?
General
