Need help?Do you have a question about the Whitfield quest and is the answer not in the manual?
Important warnings about stove installation, operation, and safety labels.
Details on fuel, operation, liquids, ashes, power, auger, soot, and cleaning.
Information on safety testing procedures and relevant standards (ASTM, UL, CSA).
Explains power outage, overheating, and safe shutdown mechanisms.
Approved pellet types and specifications for chlorides, density, moisture, ash, and fines.
Explains clinkering causes and ash removal frequency based on fuel type.
Discusses how pellet size, length, and density affect feed rates.
Explains the function of buttons and knobs on the stove's control panel.
Steps to prime the auger and light the stove with or without the FASTFIRE™ igniter.
Instructions on how to safely shut down the pellet stove.
Covers burn characteristics, pellet size, burn time, and ash slide plates.
Lists areas needing inspection and cleaning: grate, tubes, baffle, ash pan, vent, gasket, motors.
Instructions for cleaning the burn grate and heat exchanger tubes.
Procedures for emptying ash pans and cleaning exhaust ducts.
Checking gasket integrity and annual lubrication for fan motors.
Steps for removing packaging and securing the stove to its pedestal.
Specifies need for non-combustible floor pads/hearths and their dimensions.
Details minimum clearances to combustible materials around the stove.
Provides a disclaimer on installation responsibility and a checklist for proper setup.
Guide to calculating equivalent pipe length for exhaust system requirements.
Guidelines for venting freestanding models, including pipe type and termination.
Procedures for venting insert models into existing chimneys or using specific vent pipes.
Detailed steps for installing a horizontal exhaust system for freestanding stoves.
Instructions for venting a freestanding stove into an existing masonry chimney.
Steps for venting the stove vertically through a ceiling and roof.
How to connect the stove's vent to an existing metal Class 'A' chimney.
Specific requirements for installing the stove in a mobile home.
Instructions for installing the insert model into a masonry or factory-built fireplace.
Addresses lazy flame, pellet buildup, soot, stove shutdown, and pellet feeding issues.
Troubleshoots automatic shutdown, fans not operating/shutting off, and power issues.
Addresses igniter problems, soot/ash in house, and cleaning with wrong vacuums.
Describes shrouds, pedestal support kits, and gold-plated louvers for insert stoves.
Covers centering adapters, decorative log sets, and FASTFIRE™ self-igniter kits.
General| Brand | Whitfield |
|---|---|
| Model | quest |
| Category | Pellet stove |
| Language | English |
To Next Page
