37
WARNING - Read all the safety and general instructions.
Failure to observe the safety and general instructions may result
in electric shock, re and/or serious injury.
• Read and observe the safety warnings and directions contained
in all the eBike system operating instructions and in the operating
instructions of your eBike.
• Carefully cover the charging socket with the ap after charging
the eBike. This ensures that no dirt or water gets in.
• Do not expose the charger to rain or wet conditions. If water
enters a charger, there is a risk of electric shock.
• Only charge Li-ion batteries approved for Kynamic eBikes with
approved Kynamic chargers. The battery voltage must match the
battery charging voltage of the charger. Only charge rechargeable
batteries. Otherwise, there is a risk of re or explosion.
• Keep the charger clean. Dirt poses a risk of electric shock.
• Always check the charger, cable and plug before use. Stop using
the charger if you discover any damage. Do not open the charger.
Damaged chargers, cables and plugs increase the risk of electric
shock.
• Do not operate the charger on an easily ignited surface (e.g.
paper, textiles, etc.) or in a ammable environment. There is a risk of
re due to the charger heating up during operation.
• Take care if you touch the charger while it is charging. Wear
protective gloves. The charger can get very hot, especially when the
ambient temperature is high.
• The eBike battery may give off fumes if it becomes damaged
or is used incorrectly. Ensure the area is well ventilated and seek
medical attention should you experience any adverse effects. The
fumes may irritate the respiratory system.
• Before every charge check the Battery for signs of damage.
Never charge a damaged battery
• Charger light warning. If the LED light on the charger does not
light up, this suggests there is problem with the charger or battery.
Please return the bike and charger to your nearest Whyte retailer for
diagnosis.
• Do not leave batteries charging for more than 24 hours, if the
charging cannot be completed in 8 hours, contact your nearest
whyte retailer to have a battery health check
Charging the Battery
- Plug the charger into the outlet. Pay attention to the mains voltage.
The voltage of the power source must match the voltage specied on the
rating plate of the charger.
-Locate the eBike charge port and lift the cover. Plug the charger into the
socket. Illustration below may differ slightly from the actual conditions
depending on the equipment of your eBike.
CHARGING INSTRUCTIONS
To Next Page
Loading...
