36
Battery ChargerIntended Use
In addition to the functions described in this manual, changes to
software relating to troubleshooting and functional modications may be
introduced at any time.
The Kynamic eBike chargers are intended exclusively for charging
Kynamic eBike batteries and must not be used for any other purpose.
Charging process
The charging process begins as soon as the charger is connected to the
eBike battery or charging socket on the eBike and to the mains.
Note: The charging process is only possible when the temperature of
the eBike battery is within the permitted charging temperature range.
Note: The drive unit is deactivated during the charging process.
The eBike battery can be charged with or without the on-board
computer.
WARNING - There is a risk of re due to the charger heating
up during charging. Ensure the eBike battery on the eBike
is completely dry and placed on a reproof surface before
charging. If this is not possible, remove the eBike battery from
the holder and charge it in a more suitable location. When
doing so, read and observe the operating instructions of the
eBike battery. Whyte does not recommend removing the
battery unless you are a skilled biked mechanic. If there is any
doubt please contact your Whyte dealer.
CAUTION - Your eBike will come partially charged. Ensure you
have fully charged the battery before your rst ride. Where
possible always store the bike fully charged to extend battery
life span.
CHARGING INSTRUCTIONS
To Next Page
Loading...
