widos 4001 - Elements on the Right Side

Kunststoffschweißtechnik
Operating and indicating elements Chapter 4
25.06.12 Working instructions WIDOS 4001 Page 17 of 59
No. Denomination Function
8 Valve lever For opening / closing the slide. There are 4 different
positions:
- FORWARDS: slide is closed.
- in the center (without moving): the instantaneous
pressure is held (also by means of the built in pressure
reservoir).
- Pressure release: a possible pressure can be released
without opening the machine. Due to the pressure
reservoir it takes approx. 10 s until the complete
pressure is released.
- BACKWARDS: slide is opened.
9 Place for stop watch - Place for the delivered stop watch giving a good view
on it.
10 Oil dipstick - Oil filler neck / checking the oil level. Oil level must be
between the two marks.
11 Manometer - Indication of the hydraulic pressure
12 Setscrew for pressure relief
valve
- Limitation of the hydraulic pressure onto the desired
value. (adjustable from 0 - 250 bar)
4.2. Elements on the right side
No. Denomination Function
1 Clamping lever - Loosen for moving the right table half, for horizontal
mismatch compensation.
1