Kunststoffschweißtechnik
Description of product Chapter 1
25.06.12 Working instructions WIDOS 4001 Page 7 of 59
1.2. Safety measures
In case of wrong use, wrong operation or wrong maintenance the machine itself or products
being in the surrounding can be damaged or destroyed.
Persons being in the endangered area may be injured.
Therefore these working instructions have to be thouroughly read and the corresponding
safety advices must necessarilly be adhered to.
1.3. Conformity
The machine corresponds in its construction to the valid recommendations of the European
Community as well as to the according European standard specifications.
The development, manufacturing and mounting of the machine were made very carefully.
1.4. Marking of product
The product is marked by a type-plate at the basic machine.
It contains the machine type, the serial number and the year of construction.
1.4.1. Technical data
1.4.1.1. WIDOS 4001 general data
Material: PP; PE 80; PE 100, PVDF
Pipe dimension: Outside-∅ = 90 – 315 mm;
with conversion kit: Outside-∅ = 90 – 450 mm
Total weight (without packing): 285 kg
Fuse protection: 16 A
Power section: 2,5 mm²
Emissions - Noises exceeding 80 dB (A) may occur; during
planing it is obligatory to wear ear protection!
- When using the named plastic materials and
when welding below 260 °C no toxicant damp
arises.
Environmental conditions in the
welding area
- take care for cleanness (no dust at the welding
area)
- if secured by an appropriate measurement that
allowed conditions for welding are indicated, it is
possible to work in any outside temperature
condition as far as the welder is not constrained
in its manual skill.
- avoid humidity, if necessary use a welding tent
- avoid strong sun rays influence
- protect from wind, shut the pipe ends
To Next Page
Loading...
