EasyManua.ls Logo

Wilo Drain TMT 32M - Temporary Decommissioning; Decommissioning for Maintenance Work or Storage; Removal; Return Delivery;Storage

Wilo Drain TMT 32M
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation and operating instructions Wilo-Drain TMT 32M 35
MAINTENANCEANDREPAIR English
thathasbeenofciallyapprovedmaybeusedfor
lowering and raising the pump.
RISK of fatal injury due to malfunctions!
Lifting gear and equipment must be in
perfect technical condition. Work may only
commence if the lifting equipment has been
checked and found to be in perfect working
order. If it is not inspected, fatal injuries may
result.
7.1. Temporary decommissioning
Forthistypeofdeactivation,thepumpremains
installed and is not cut off from the electricity
supply. In the event of temporary decommission-
ing the pump must remain completely immersed
so that it is protected from frost and ice. Ensure
thatthetemperatureoftheuidandinthecol-
lectortankdoesnotfallbelow+3°C.
This ensures that the pump is always ready for
operation.Forextendeddowntime,aregular
(monthlytoquarterly)5minutefunctiontest
should be carried out.
CAUTION!
Only perform function runs under the proper
operating and usage conditions. Never run
the machine dry! This can result in irreparable
damage!
7.2. Decommissioning for maintenance work or
storage
The system must be switched off and the pump
must be disconnected from the mains by an
electrician and secured against being switched
onagainwithoutpermission.Workonremoval,
maintenance and storage can then commence.
BEWARE of poisonous substances!
Pumps that pump liquids hazardous to health
must always be decontaminated before un-
dertaking any other work. Otherwise, there
is a risk of fatal injury! Wear the necessary
physical protection equipment!
BEWARE of burns!
The housing parts can heat up to above
100°C. There is a risk of burns! After switch-
ing it off, let the pump cool down to ambient
temperature.
7.3. Removal
Allslidevalves(inletandpressurepipe)mustbe
shuttopreventfurtheruidfromowingintothe
operating space. The operating space can then
be drained and the pump disconnected from the
pipingandthepressurehose.Liftthepumpoutof
theoperatingspace;asuitableliftingdevicemay
be required to do this.
7.4. Return delivery/storage
Forshipping,thepartsmustbepackedintear-
proofplasticbagsofsufcientsizeinsucha
manner that they are tightly sealed and leak-
proof.
For return delivery and storage please also refer
to the “Transport and storage” section!
7.5. Disposal
7.5.1. Operating materials
Oilsandlubricantsmustbecollectedinappropri-
ate containers and properly disposed of in terms
ofECDirective75/439/EECaswellasincompli-
ance with the provisions of sections 5a and 5b
of the German Waste Act or the applicable local
laws.
7.5.2. Protective clothing
Protective clothing worn for cleaning and main-
tenance work is to be disposed of in accordance
withtheGermanWasteCodeTA52402andEC
Directive91/689/EEC.
7.5.3. Product
Proper disposal of this product avoids damage to
the environment and risks to personal health.
Use the services of public or private waste dis-
posalcompanies,orconsultthemforthedisposal
of the product or parts thereof.
Formoreinformationonproperdisposal,please
contactyourlocalcouncilorwastedisposalofce
or the supplier from whom you obtained the
product.
8. Maintenance and repair
ELECTROCUTION hazard!
There is a risk of fatal electric shocks when
performing work on electrical devices. With
all maintenance or repair work, the pump
must be disconnected from the mains and
secured against being switched on again
without permission. Damage to the power
supply cable may only be rectied by a quali-
ed electrician.
Beforeanymaintenanceorrepairwork,thepump
must be deactivated and dismantled as described
inthe“Decommissioning/disposal”chapter.
Aftermaintenanceorrepairwork,thepumpmust
be installed and connected as described in the
“Installation”chapter.
The pump is switched on as described in the
“Commissioning”chapter.
Notethefollowing:
All maintenance and repair work must be carried
outbyWilocustomerservice,authorisedservice
workshops or trained specialists with the greatest
of care and in a safe workplace. Proper protective
clothing is to be worn.
This manual must be available to and observed
bythemaintenancestaff.Onlymaintenance
and repair work described in this manual may be
carried out.

Related product manuals