Wilo Wilo-Stratos PICO 25/1-6 User Manual

Installation and operating instructions Wilo-Stratos PICO 3
English
Installation and operating instructions
1 General
About this document
The language of the original operating instructions is German.
All other languages of these instructions are translations of the
original operating instructions.
These installation and operating instructions are an integral
part of the product. They must be kept readily available at the
place where the product is installed. Strict adherence to these
instructions is a precondition for the proper use and correct
operation of the product.
The installation and operating instructions correspond to the
relevant version of the product and the underlying safety regu-
lations and standards valid at the time of going to print.
EC declaration of conformity:
A copy of the EC declaration of conformity is a component of
these operating instructions.
If a technical modification is made on the designs named there
without our agreement or the declarations made in the instal-
lation and operating instructions on product/personnel safety
are not observed, this declaration loses its validity.
2 Safety
These operating instructions contain basic information which
must be adhered to during installation, operation and mainte-
nance. For this reason, these operating instructions must with-
out fail be read by the service technician and the responsible
specialist/operator before installation and commissioning.
It is not only the general safety instructions listed under the
main point “safety” that must be adhered to but also the special
safety instructions with danger symbols included under the fol-
lowing main points.

Wilo Wilo-Stratos PICO 25/1-6 Specifications

General

Max Head	6 m
Voltage	230 V
Protection Class	IP42
Max Operating Pressure	10 bar
Installation Length	180 mm
EEI	≤ 0.20
Type	Circulating Pump
Supply Voltage	1 x 230 V, 50/60 Hz