Windsor Saber Glide SG28 User Manual (English)

Other manuals for Windsor Saber Glide SG28

Questions and Answers:

L
lcummingsSep 7, 2025
Why is my Windsor Saber Glide SG28 not picking up water properly?
- T
  Tracy TorresSep 7, 2025
  If your Windsor Scrubber isn't picking up water effectively, several factors could be responsible. Start by adjusting the squeegee to ensure it makes proper contact with the floor. Check for and remove any debris caught on the squeegee. If the squeegee blades are worn, rotate or replace them. Inspect the vacuum hose for clogs and clear any obstructions. Ensure the vacuum hose is securely connected to both the squeegee and the recovery tank. If the hose is damaged, replace it. Also, check the vacuum motor inlet filter; if it's dirty, clean or replace it. Make sure the recovery tank is sealed correctly, replacing any damaged seals if necessary. Finally, if foam is filling the recovery tank, empty it and consider using less detergent, a different detergent, or a defoamer.
D
Deborah MunozSep 9, 2025
Why is there little or no solution flow to the floor from my Windsor Scrubber?
- D
  David BeanSep 9, 2025
  If your Windsor Scrubber has little to no solution flow, start by checking if the solution tank is empty and fill it if needed. Ensure the solution flow is turned on and set to an adequate level. Inspect the solution strainer for any blockages and clean it. Check the solution system plumbing for obstructions and clear them. Examine the solution solenoid valve for obstructions or if it's stuck, and clean or replace it as necessary. Make sure the vent hole in the solution tank lid is clear. Finally, check the wiring to the solution valve to ensure there are no faulty connections.
M
Mark WilliamsSep 12, 2025
Why won't the squeegee on my Windsor Saber Glide SG28 go up or down?
- K
  Katherine ChapmanSep 12, 2025
  If the squeegee on your Windsor Scrubber is not moving up or down, the issue could be due to a loose connection in the wires from the controller to the actuator, so check these connections. Alternatively, the actuator itself might be faulty and require repair or replacement.
B
Bonnie StrongSep 12, 2025
What causes poor scrubbing performance in a Windsor Scrubber?
- R
  Rhonda Brandt PhDSep 12, 2025
  Poor scrubbing performance in your Windsor Scrubber can stem from several causes. Start by checking the scrub brushes for any caught debris and remove it. If the brushes or pads are worn, replace them. It's also important to ensure you are using the proper detergent, brush, or pad for your specific application; consult with equipment or application specialists if needed. Increasing the brush pressure can also improve performance. Finally, ensure that the battery is adequately charged.
A
Anna GordonSep 14, 2025
What should I do if the scrub deck on my Windsor Saber Glide SG28 won't go up or down?
- J
  Juan MyersSep 14, 2025
  If the scrub deck on your Windsor Scrubber isn't moving up or down, first check the motor wires and connections for any looseness. If the connections are secure, the actuator itself may be faulty and require repair or replacement.