Maintenance
2138−1/A2
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
3/ 4
3. Checking a non-return valve
For judging the proper functioning of the non-return valve an opening pressure test
(opening pressure = 5 bar) must be carried out.
During testing the lubricating quill should be kept in horizontal position and an oil
with a viscosity of either SAE 50 at 40_C (approx. 200 cSt) or SAE 30 at 25_C
(approx. 190 cSt) must be used.
3.1 Test procedure
D Instead of screw-in union, fit connection nipple 94934I into lubricating quill.
⇒ Connect lubricating quill 5 to oil pump 94931 as shown below.
⇒ Vent the lubricating quill.
⇒ Apply a pressure of 2 bar and increase it in steps of 1 bar until the non-return
valve opens.
⇒ Note down the opening pressure.
Remark: The opening (cracking) pressure should be at least 4.25 bar for correct
functioning.
With an opening pressure below 4.25 bar the non-return do not function properly or
it is damaged and must be replaced.
C
5
94935
94931
8
94934H
WCH00112
94934I
Pulse Jet / 2013
Lubricating Quill with Pulse Jet Lubrication
To Next Page
Loading...
