WinGD WARTSILA RT-flex58T-E - Supply Unit, Injection and Exhaust Valve Control (Group 5)

RT-flex58T-E
Maintenance0002−1/A1
Table of Contents
4/ 5 Winterthur Gas & Diesel Ltd.
2015-08
Supply Unit, Injection and Exhaust Valve Control Group 5
 Supply Unit
− Removal and Fitting of Servo Oil Pump and Servo Oil Pump Drive 5552−1/A1.........
− Removal and Fitting of Camshaft and Bearing Shells 5552−2/A1.....................
− Removing and Fitting the Gear Wheel on Camshaft 5552−3/A1......................
− Removal and Fitting 5552−4/A1..................................................
− Lubrication of Supply Unit During Maintenance Works 5552−5/A1....................
Fuel Pump: Dismantling and Assembling 5556−1/A1..................................
Fuel Pressure Control Valve: Removal, Fitting, Dismantling and Assembling 5562−1/A1....
Fuel Overpressure Safety Valve: Checking and Setting 5562−2/A1......................
Injection Control Unit: Removal and Fitting 5564−1/A1.................................
Pressure Reducing Valve 8.11−1: Checking the Gas Pre-charge Pressure 5610−1/A1.....
Exhaust Valve Control Unit:
Removal, Fitting, Dismantling and Assembling 5612−1/A1..............................
 Regulating Linkage
− Adjusting: with Heinzmann StG 10-01 Actuator 5801−1/A1..........................
− Adjusting
: with Woodward ProAct II − Analog Actuator 5801−1/A2....................
Scavenge Air Receiver and Auxiliary Blower Group 6
Scavenge Air Receiver: Checking the Air Flaps
and Cleaning the Scavenge Air Receiver 6420−1/A1..................................
Auxiliary Blower: Maintenance 6545−1/A1............................................
 Scavenge Air Cooler
− Cleaning (Water Side) on Engine at Standstill 6606−1/A1...........................
− Removal and Fitting of Tube Stack 6606−2/A1.....................................
 Water Separator
− Maintenance of Water Separator (1-part Water Separator) 6708−1/A1................
− Maintenance of Water Separator (2-part Water Separator) 6708−1/A2................
Cylinder Lubrication Group 7
Lubrication Pump CLU4−C: Checking the Gas Pre-charge Pressure 7218−1/A2...........
Piping Group 8
Exhaust Waste Gate (Low-Load Tuning) 8135−1/A1...................................
HP Servo Oil Pipe: Removing, Fitting and Regrinding 8447−1/A1.......................
Hydraulic Pipe for Exhaust Valve Drive: Removing, Fitting and Regrinding 8460−1/A1.....
HP Pipe to Injection Valve: Removing, Fitting and Regrinding 8733−1/A1.................
HP Pipe to Injection Valve (for ICU Mk3): Removing, Fitting and Regrinding 8733−1/A2....
HP Fuel Pipe: Removing, Fitting and Regrinding 8752−1/A1............................