Maintenance5801−1/A1
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
2/ 3
2. Adjusting of regulating linkage
⇒ Place adjusting scale 94575 on ac-
tuator 2 as shown in Fig. ’B’. Push
the tool against centring flange 3
aligning it parallel with the outer ac-
tuator edge simultaneously. Main-
tain this position during the following
adjusting works.
⇒ Rotate actuator shaft 4 in counter-
clockwise direction until the internal
stop of the actuator (minimum stop).
⇒ Put lever 5 with inserted sleeve 6 and
adjusting pin 94575A on actuator
shaft 4 so that the pinpoint points at
0_-line as exactly as possible.
⇒ Slightly tighten screw 7.
⇒ Rotate lever 5 to 75_-mark (maxi-
mum stop) so that also in this posi-
tion the pinpoint points at 75_-line as
exactly as possible.
⇒ Compensate possible differences
with regard to 0_- and 75_-lines by
means of turning lever 5 on sleeve 6.
⇒ Tighten screw 7.
⇒ Mark the lever position to the actua-
tor shaft with the aid of slight center
punch strokes ’MA’.
⇒ Remove the adjusting tools.
B
012.883/05
1
5
2
3
I
I
5
94575
94575A
94575
94575A
7
MA
4
6
Regulating Linkage: Adjusting with Heinzmann StG 10-01 Actuator
2013
To Next Page
Loading...
