Priming the fuel system
Prime the system as follows:
Fill the fuel tank
Move the engine control lever to the
RUN position.
Release the bleed screw (O) on the
filter head, then operate the priming
lever (P) on the lift pump until a full air
free flow is obtained
Retighten bleed screw (O)
Vent each injector pump in turn by
releasing screw (R), then operate the
priming lever (P) on the lift pump until a
full air free flow is obtained
Retighten bleed screw (R), then repeat
for the other injector pump.
3.8 SERVICE
ENGINE
To Next Page
Loading...
