Engine lubrication oil
For engine oil grades and oil change
periods when operating in temperatures
above 30
o
C, see “Engine Handbook”.
WARNING Lubrication oil cleanliness is
vital for the successful
operation of your engine. The
oil should be stored under the
cleanest possible conditions.
When changing or topping-up
oil, use only clean
receptacles.
Always wear protective gloves
when handling oils for
topping up, draining, or
refilling.
Oils and fuels can cause skin
irritation. Wear suitable
protective clothing to prevent
skin contact.
After handling oils the users
hands should be thoroughly
washed, particularly before
eating.
Every 10 operating hours, or
daily
Engine oil level
Check lubrication oil level as follows:
Stop the engine and allow the oil to
settle.
Remove and clean the dipstick (B),
then check that the oil is at the full
mark. If the level is low, top up through
the filler (C) to the full mark with clean
oil of the correct grade. DO NOT
OVERFILL.
For correct grade of engine oil, see
“Specifications”.
3.4 SERVICE
ENGINE
Engines fitted in dumpers
Up to 1985: Lister ST2 and Petter PH2
1985 to 1989: Lister-Petter PH2
1985 to 1989: Lister-Petter TS2
Note: from 1989 the TS2 has been offered as an
option
1989 to date: Lister-Petter TR2
IMPORTANT
To service the following engines,
Lister ST2
Petter PH2
Please refer to relevent Engine Operator’s
Handbook or Workshop Manual.
Lister-Petter TS/TR2
These engines will require additional
services and adjustments in addition to
those quoted in this handbook. Please
refer also to the relevant Engine
Operator’s Handbook or Workshop
Manual.
To Next Page
Loading...
