SECTION 7 –
PLUMBING
7-10
Waste Pump
The 12-volt Waste Pump disposes gray
holding tank waste through a small diameter
sewer hose, which is then drained through the
main sewage drain outlet.
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Further Information
For further information and operating
cautions, see the Waste Pump operating
instructions included in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from small access
compartment located on rear driver side of
coach.
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close Black Waste Tank Drain
valve as soon as tank is empty.
Waste Pump
(Located in driver side
compartment behind rear wheel)
Sewage Drain Outlet
(Located in driver side compartment
ahead of rear wheel)
To Next Page
Loading...