Rinse aid and detergent
English 29
Dosing of the detergent powder
Pre-dosing
Fill approx. 50 g detergent powder into the machine when the programme key (6) lights up in green.
Then start a wash cycle immediately in order to mix the detergent powder with the water.
Adhere to the dosing instructions on the packaging of the detergent.
Post-dosing
Fill approx. 50 g detergent powder into the machine after 5 wash cycles.
Post-dosing for machines with manual or automatic cold water pre-wash
Note that the detergent concentration reduces more quickly in case of cold water pre-wash.
Thus, supply a greater quantity in case of constant use of cold water pre-wash.
Dosing of liquid detergent
The service engineer authorised by Winterhalter sets the dosing amount when commissioning the machine.
The storage container for the detergent must be equipped with a suction tube with level monitoring if the
level of the detergent in the machine is to be displayed.
4.4 Changing the detergent (liquid detergent)
When changing the detergent, adhere to the following:
Mixing different detergents can lead to efflorescence that can lead to a failure of the detergent dosing
device. This is applicable even if the new detergent is from the same manufacturer.
A new detergent usually requires a new setting of the detergent dosing device.
The dosing pipe and the detergent dosing device must be thoroughly rinsed with water before the
new detergent is used.
Assign the required work to a service engineer authorised by Winterhalter to attain good results.
If this is not done, the warranty and product liability of Winterhalter Gastronom GmbH expires.
This is how you should rinse the dosing pipe and the detergent dosing device:
Warning
When handling chemicals, observe the safety notes and dosing recommendations printed on
the packing.
Wear protective clothing, protective gloves and protective goggles when handling chemicals.
Do not mix different detergents.
Remove the suction pipe from the storage container with the currently used detergent and place it in a
container filled with water.
Initiate several washing programmes till the water is supplied to the machine via the detergent dosing
device. The suction and pressure pipes are rinsed here.
Place the suction pipe in the storage container with the new detergent.
To Next Page
Loading...
