WT53R-485 Manual v23-0720 | www.wit-motion.com | support@wit-motion.com
18
5.6
Return Rate
The sensor can set the automatic return speed of 0.1~100Hz (due to the
influence of the measurement distance, the time is not absolutely accurate, and
the return rate is useless in Modbus mode.) The setting process is as follows:
After connecting the sensor normally, click "Configuration" to select the
corresponding device and enter the configuration interface.
Select the desired backhaul rate from the drop-down list of Backhaul Speed, and
click.
To Next Page
Loading...
