The “Witschi Token Installer” software can be used to install
what is known as a token on the ChronoMaster to upgrade the
ChronoMaster to the PRO version.
Ordering a token
The token is created specifically for the Chrono-
Master to be upgraded. The token contains the
item number and the serial number of the Chro-
noMaster.
More information can be found in the software
manual.
Using what is known as a demo token, you can test the PRO
version for a limited time. The demo token features a time-
stamp, and can only be installed once on the ChronoMaster. If
new functions are provided by the manufacturer, a new demo
token can be created, which can be installed again once.
A USB cable is used to connect the device to the PC or tablet
computer. The measurements are controlled using the corre-
sponding “Chronoscope Service” display software.
The “Chronoscope Service” display software allows you to
choose between the “Diagram” and “Vario” display modes
for both versions. In addition, the “Trace” , “Sequence” ,
“Polar” , “Scope 1” and “Scope 2” display modes are
included with the ChronoMaster PRO version.
The ChronoMaster Air can either use a USB-C cable or a Blue-
tooth connection to communicate with the PC or tablet com-
puter.
Information on controlling the measurements
Further information on controlling the measure-
ments is to be found under
Ä
“Display modes”
on page 10, in
Ä
Chapter 4 “Performing a
measurement” on page 29 and in the corre-
sponding software manual.
Witschi Token Installer (for Chrono-
Master only)
Controlling the measurements
24.03.2021Precision measuring device ChronoMaster / ChronoMaster Air8
To Next Page
Loading...
