Wittkopp SmartCam - Operation Mode K2; Locking K2; Opening K2 with User Code; Changing User Code K2

10
SmartCam
6 Operating/programming operation mode K2
6.1 Locking K2
 
1.
Close the door at the safe and enter any key.
Turn the knob within 3 seconds into locking position. The lock is closed.
6.2 Opening
6.2.1 Opening with user code
 
1. Enter your 4-/6-digit code e.g. user code.
3333
/
33
2.
Turn the knob within 3 seconds into opening position.
The lock is opened.
6.2.2 Opening with master code K2
 
1.
Press and hold the key “8“ for approx. 3 seconds.
When releasing the key the green LED lights up permanently.
8
2.
Enter your 6-digit master code e.g.
123456
3.
Turn the knob within 3 seconds into opening position.
The lock is opened.
• After a wrong code input a long signal tone occurs and the red LED flashes.
• After 4 consecutive wrong code inputs, a blocking time of 1 minute occurs. During this blocking time the red LED flashes
every 10 seconds. It is not possible to insert a code during the blocking time is active. After the blocking time expires the red
LED stops flashing. After the blocking time has passed 2 further incorrect inputs will restart the blocking time of 1 minute.
6.2.3 Changing the user code K2
 
1.
Press and hold the key “0“ for approx. 3 seconds.
When releasing the key the green LED lights up permanently.
0
2. Enter the following digit for the type of change.
0 by the master or
1 by the user
3. Enter your 6-digit master code or your 4-/6-digit user code e.g. user.
4444
/
44
4.
Enter your new 4-/6-digit user code e.g.
1111
/
11
5.
R-enter your new 4-/6-digit user code e.g.
1111
/
11
6. The new user code is accepted.